Welding Tips and Tricks

Howdy,

I tried my hand at square tube today. I've been practicing with straight beads and t joints since I got my welder about 3 weeks ago. This is 1 3/4 .090 wall tube. I was dialing the settings as I went and I think I found the sweet spot by the time I did the fillet joint. The other one was still a bit cold I think. Please comment, all criticism is welcome

Square tube welds by Jay, on Flickr

Square tube welds by Jay, on Flickr

Your right, how fast are you travelling. You look fast to me.

Yep slow it down some and point your angle just a little more down on the bottom piece.