Chipping Hammer-not a "chicken hammer"

Chuck · Tue Apr 08, 2014 12:08 am

: Chipping Hammer.jpg (28.71 KiB) Viewed 1592 times

I found a very small estwing ball peen at a thrift store cheap and added half a chisel--works great and it serves dual purposes. Also-I've fount a mehanic's magnetic tray is a great place for the hot tail end of rods to keep them from getting in a tire or starting a grass fire, etc.

paul_s · Tue Apr 08, 2014 12:43 am

Welcome to the forum, Chuck. That's a great idea for the rod ends.

Bill Beauregard · Tue Apr 08, 2014 8:19 am

OK. I pound a boneless chicken breast flat, put filling in and roll it. What should I call that hammer?

coldman · Tue Apr 08, 2014 8:54 am

A stress reliever.

Mike · Tue Apr 08, 2014 11:03 am

Welcome to the forum Chuck.

Superiorwelding · Tue Apr 08, 2014 10:56 pm

Chuck,
Very nice hammer! I am very curious as to how you "welded" that chisel to the hammer.
-Jonathan

Chuck · Thu Apr 10, 2014 12:54 am

Hi Johnathan,
I preheated both pieces and tig welded with 309 stainless rod. I'm sure it's not recommended to weld on hammers but have been using it for many months and it seems to be holding together fine. In several of Jody's videos he jokes about not using the pick side of a chipping hammer, hence the idea for the tool and the post title,
Thanks for asking and the warm welcome,
Chuck