[AKweldshop]

DSCN1797 CRANE NUMBER !!!!!!!!!.JPG (87.43 KiB) Viewed 1281 times

DSCN1800 CRANE ###### %%%%%%.JPG (87.02 KiB) Viewed 1281 times

[AKweldshop]

IMG_1714.JPG (103.02 KiB) Viewed 1279 times

IMG_1724.JPG (164.92 KiB) Viewed 1279 times

[Superiorwelding]

John,
Is this your latest find? That will be handy to have around. Looks custom made, never seen one built quite like that before.
-Jonathan

[AKweldshop]

You want to come up and help me set it up??

My buddy had it, and I did some bartering for it.

Drove up to his place and brought it home.

Has a 3 ton chainfall on a trolly.

It's 14ft high, and 20ft wide.

[Superiorwelding]

You want to come up and help me set it up??

My buddy had it, and I did some bartering for it.

Drove up to his place and brought it home.

Has a 3 ton chainfall on a trolly.

It's 14ft high, and 20ft wide.

If you were closer, absolutely!
I will get a picture of the one in my garage, looks similar to this one but a lot smaller. Mine started out 14' tall also and I cut it down to 10' to fit in my garage. I have nothing but time and 8 bolts in mine. It was left by the previous occupant of my very first shop, I like freebies.
-Jonathan
-Jonathan

[mcoe]

Nice, better than my crane! I have a heavy old horseshoe lag bolted to the rafters and I hooked a 2 ton come along to it Crude,ugly, but works for me.