3 point tractor hitch

robson1015 · Wed May 14, 2014 4:27 pm

: IMGP2239.JPG (111 KiB) Viewed 1251 times

AKweldshop · Wed May 14, 2014 4:36 pm

Very nice!!
Did you build it from scratch?

robson1015 · Wed May 14, 2014 4:38 pm

yes - 5x5 angle, draw bar, 6" hitch tube.....

Superiorwelding · Wed May 14, 2014 4:40 pm

Very nice craftsmanship! I built one similar for a friends Kubota a few weeks ago. Should have taken pictures of it.
-Jonathan

AKweldshop · Wed May 14, 2014 4:42 pm

I bought one a week ago.

robson1015 · Wed May 14, 2014 4:43 pm

Thanx neighbor-Wooster about an hour north of me

AKweldshop · Wed May 14, 2014 4:46 pm

Superiorwelding wrote:Very nice craftsmanship! I built one similar for a friends Kubota a few weeks ago. Should have taken pictures of it.
-Jonathan

Why don't you take pics of everything you work on??
I try and document most of the work I do.
Gives assurance to new customers.

Wish I'd of started yrs ago.

noddybrian · Wed May 14, 2014 4:54 pm

Ah -yes- looks good - but what was it welded with ? ( !! ) - careful - AK's reading this ! if 6013 even got near it while you were welding the entire thing may just fly apart killing dozens ! - lucky it only looks like a Cat 1 - if it was bigger that may have been hundreds !

robson1015 · Wed May 14, 2014 5:01 pm

Ha Ha Ha 6010 covered with 7018......

noddybrian · Wed May 14, 2014 5:05 pm

Phew - that's a relief ! your golden then ! - only a thought - but capping the vertical box would keep it from filling up with water / mud & add a little strength.

robson1015 · Wed May 14, 2014 5:10 pm

Good suggestion - thank you...

AKweldshop · Wed May 14, 2014 5:17 pm

robson1015 wrote:Ha Ha Ha 6010 covered with 7018......

You da man!!

Good choice!!

AKweldshop · Thu May 15, 2014 3:17 am

I'd better grind the factory mig welds out, and weld it with 6013.
Got some great 6013 here.

: IMG_2203.JPG (102.8 KiB) Viewed 644 times

: IMG_1484.JPG (136.68 KiB) Viewed 644 times