Welding Tips and Tricks

base:
2" hr angle
1 1/4" sq hr tube
1/8" sheet steel base
drawers:
22 ga steel
1/8" alum diamond palte
Top:
1" alum sq tube
1/8 alum sheet.
sides:
alum sheet
5" casters

Excellent workmanship
Very snazzy!


Sent using Tapatalk

I always like stuff that's mixed materials. Nice work!

Wow! Beautiful!

Very nicely done. Beautiful work.

You really took cart building to another level there Craig. Very nice design and top notch craftmanship.

Like the Logan lathe too. I see you're also one of those fellers that like their tig wire all nice and neat and protected..

jeff
had them on a cart but then i hijacked Jody's mount to wall idea.
already had the tubes build just needed to make the clips
for the wall mount. neat and out of the way now.
craig

motox wrote:jeff
had them on a cart but then i hijacked Jody's mount to wall idea.
already had the tubes build just needed to make the clips
for the wall mount. neat and out of the way now.
craig

I'm afraid I have been shamed into making some tubes....damn you guys

blame Jody, not me..lol

exnailpounder wrote:

motox wrote:jeff
had them on a cart but then i hijacked Jody's mount to wall idea.
already had the tubes build just needed to make the clips
for the wall mount. neat and out of the way now.
craig

I'm afraid I have been shamed into making some tubes....damn you guys

If you do this you run the risk of seeming to be organized...

richard wrote:If you do this you run the risk of seeming to be organized..

but still very crazy.......