Page 1 of 1
Filler Wire container
Posted: Fri May 05, 2017 3:23 pm
by AndersK
Just made some smaller wire containers.
Using 1" electric conduit pipe.
Cost is roughly 3$ each.
- IMG_20170505_27983.jpg (41.19 KiB) Viewed 1225 times
- IMG_20170505_20203.jpg (34.07 KiB) Viewed 1225 times
Re: Filler Wire container
Posted: Fri May 05, 2017 4:14 pm
by LtBadd
Looks good and you can't beat that price, are the caps screw on or push? Hard to tell but it looks like threads on the caps.
Re: Filler Wire container
Posted: Fri May 05, 2017 4:36 pm
by AndersK
Push, with a bit of persuasion in the shape of heat and a rubber mallet
Re: Filler Wire container
Posted: Sat May 06, 2017 12:07 am
by MosquitoMoto
Nice.
I need to make up some small ones like these. Because my LWS's are pretty much useless, I buy most of my filler online and to make postage easier/cheaper, it is often sold in 33cm/13" length. A few, say, 14" filler containers would be very handy.
Moz
Re: Filler Wire container
Posted: Sat May 06, 2017 8:06 am
by exnailpounder
Nice Anders! Hey...I can't see anything...can you back those pics up a bit so I can look around your shop a little?
Re: Filler Wire container
Posted: Sat May 06, 2017 10:41 am
by electrode
