Welding Tips and Tricks

The Forum
https://forum.theweldingforum.com/

Gas Powered Auger Bit Repair

https://forum.theweldingforum.com/viewtopic.php?f=9&t=1189

Page 1 of 1

Gas Powered Auger Bit Repair

Posted: Fri Feb 18, 2011 5:35 pm
by madchill
Just finished up this job of putting back together a sheared off auger bit coupling end. Required, heating, straightening, mig welding of 3/16 inch material. Spins well.
All times are UTC-04:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited