We have a weight tree that we wanted wheels on. The 2x4 first try collapsed after a few months. So of course I pulled out the Hobart Handler 120, some scrap 'u' channel from the local supply store and go for it.
Here is the original
- IMG_1348.JPG (62.76 KiB) Viewed 1615 times
Cut in half, the 'u' channel needed a little cleaning and cutouts for wheel travel.
- IMG_1349.JPG (55.49 KiB) Viewed 1623 times
Added some spacers for more clearance.
- IMG_1351.JPG (37.35 KiB) Viewed 1623 times
Then the wheels.
- IMG_1352.JPG (41.17 KiB) Viewed 1623 times
- IMG_1353.JPG (51.71 KiB) Viewed 1623 times
Then attached the two caster bases. This was my first time stacking beads and learning about the limited duty cycle of my little machine.
- IMG_1354.JPG (59.93 KiB) Viewed 1623 times
The finished project also has a little angle iron sticking out of the top to hold our clips.
- IMG_1358.JPG (48.89 KiB) Viewed 1623 times
Unfortunately, as I changed out my 75/25 tank at the end I blew out the valve and will need to have it rebuilt. All in all, I'm feeling more comfortable with various thicknesses and basic fabrication concepts. I know there was probably an easier way to do this, but it's what made sense with what I had and $21 in scrap. I might paint it all later, but I live in Phoenix, so moisture and rust aren't a big concern.
Feedback is appreciated
Hobbyist MIG welder with 75/25 gas on a Lincoln SP-140 in my garage/workshop/gym/storage space. Very new and still learning.
"Service is the rent you pay for room on this earth" - Shirley Chisholm
