Page 1 of 1
Latest project back from powder coating
Posted: Mon Oct 22, 2018 11:47 am
by Jim FLinchbaugh
New rack for the front of the ice fishing machine. Old one too small and bent to heck
Had to build a die for the bender to bend the tubing lol
Tacked up
- 43395756_2441890672493926_8166136708476174336_n.jpg (103.02 KiB) Viewed 1486 times
Re: Latest project back from powder coating
Posted: Mon Oct 22, 2018 12:18 pm
by LtBadd
Nice job Jim, how long before you'll be able to ice fish?
Re: Latest project back from powder coating
Posted: Mon Oct 22, 2018 6:05 pm
by Jim FLinchbaugh
unknown, lol
Almanac says we are in for an ElNino. Usually around here mid to late December at the earliest.
Used to be in the 80's early to mid November had everything froze, but at that time 10-16 days of 30 below was normal over Thanksgiving.
Not anymore
Re: Latest project back from powder coating
Posted: Mon Oct 22, 2018 6:09 pm
by tungstendipper
We ice fish, here in Colorado (Rockies) in mid November, most of the time.
Re: Latest project back from powder coating
Posted: Tue Oct 23, 2018 4:11 am
by weldin mike 27
I don't believe there's a lake in Australia that freezes solid.