Dutch Oven Table
Posted: Thu Aug 01, 2019 1:32 pm
Needed a table at home from some dutch oven cooking in the driveway. Built this over the course of a weekend and it did the trick. Its 3/16 angle, flatbar, and pipe with a 14ga sheet top welded with 1/16 er70s-6 tig filler. Everything was cut and beveled with an angle grinder.
Also needed a little filler holder to separate my used rods so used some scraps. Stainless sheet to stainless tubing welded with .045 308L and 1/16 SiB.
Also needed a little filler holder to separate my used rods so used some scraps. Stainless sheet to stainless tubing welded with .045 308L and 1/16 SiB.
- IMG_3060.JPG (54.67 KiB) Viewed 1119 times
- IMG_3063.JPG (32 KiB) Viewed 1119 times
- IMG_3058.JPG (42.78 KiB) Viewed 1119 times
- IMG_3057.JPG (33 KiB) Viewed 1119 times
- IMG_3039.JPG (102.65 KiB) Viewed 1119 times
- E0756056-8B71-42D6-9D25-A0D48F2D4A8C.JPG (66.87 KiB) Viewed 1119 times
- IMG_3052.JPG (57.49 KiB) Viewed 1119 times