Page 1 of 1
Bandsaw stand
Posted: Sat Sep 19, 2020 8:33 pm
by DavidR8
With some trepidation I’m posting a pic of the bandsaw stand I’m making.
Still need to add brackets for the saw, chip tray holder and casters.
Material is .060 wall, 1” tube.
Took me a bit to sort out settings on my Millermatic 130. The welds look like crap but they are strong.
Sent from my iPhone using Tapatalk
Re: Bandsaw stand
Posted: Sat Sep 19, 2020 9:23 pm
by tweake
nice job
Re: Bandsaw stand
Posted: Sat Sep 19, 2020 9:25 pm
by DavidR8
tweake wrote:nice job
Thanks!
Sent from my iPhone using Tapatalk
Re: Bandsaw stand
Posted: Sat Sep 19, 2020 9:27 pm
by Oscar
Looks good David.
Re: Bandsaw stand
Posted: Sat Sep 19, 2020 9:27 pm
by DavidR8
Oscar wrote:Looks good David.
Thanks Oscar!
Sent from my iPhone using Tapatalk
Re: Bandsaw stand
Posted: Sat Sep 19, 2020 10:03 pm
by LtBadd
Get some paint on there and it'll serve you well
Re: Bandsaw stand
Posted: Sat Sep 19, 2020 11:57 pm
by av8or1
Thumbs up!
Re: Bandsaw stand
Posted: Sun Sep 20, 2020 12:05 am
by DavidR8
Thanks gents!
With any luck I’ll get the brackets made and tomorrow and then I can finish it up.
Sent from my iPhone using Tapatalk
Bandsaw stand
Posted: Sun Sep 20, 2020 10:08 pm
by DavidR8
Chip tray brackets made and installed.
(No welding tho...)
Sent from my iPhone using Tapatalk
Re: Bandsaw stand
Posted: Mon Sep 21, 2020 1:46 am
by DavidR8
Chip tray in and doing it’s job, saw is bolted down, very sturdy.
Just needs paint now.
Sent from my iPhone using Tapatalk