Multi machine cart
Posted: Mon Dec 17, 2012 9:22 pm
Hey All,
I'm thinking of building a cart for my Lincoln Square Wave 175, Miller Spectrum 375 and my O/A setup with a hose reel. My question is other than it being a large heavy cart that will require the appropriate casters, is there any reason not to do this? The reason I'm asking is because I haven't really seen anyone do this. My shop space is at a premium and I'm thinking this can alleviate some of my lack of space issues. I'm gonna try this configuration: tig on the bottom, plasma cutter on top of that, argon bottle behind tig and O/A setup on the side of the tig. My O/A reel and cables for the tig and plasma will be on the same side as the O/A bottles I think. I'll make a place for the tig rods, consumables, plasma consumables,helmets and face shields, and torch accessories.
If anyone has a good link to one that was built, let me know. I'm always up for better ideas.
Obviously if I'm overlooking something, please let me know. Hopefully in the next couple weeks I can get started on this and I'll post progress here.
Thanks,
Jason
I'm thinking of building a cart for my Lincoln Square Wave 175, Miller Spectrum 375 and my O/A setup with a hose reel. My question is other than it being a large heavy cart that will require the appropriate casters, is there any reason not to do this? The reason I'm asking is because I haven't really seen anyone do this. My shop space is at a premium and I'm thinking this can alleviate some of my lack of space issues. I'm gonna try this configuration: tig on the bottom, plasma cutter on top of that, argon bottle behind tig and O/A setup on the side of the tig. My O/A reel and cables for the tig and plasma will be on the same side as the O/A bottles I think. I'll make a place for the tig rods, consumables, plasma consumables,helmets and face shields, and torch accessories.
If anyone has a good link to one that was built, let me know. I'm always up for better ideas.
Obviously if I'm overlooking something, please let me know. Hopefully in the next couple weeks I can get started on this and I'll post progress here.
Thanks,
Jason