Page 1 of 1
repairing a broken shaft
Posted: Wed Jan 08, 2014 1:07 am
by spkrman15
Here are some pictures of a machining job where I had to weld in a shaft. This weld was done with an HTP tig set on arc at 100 amps.
Re: repairing a broken shaft
Posted: Wed Jan 08, 2014 1:13 am
by spkrman15
- Machining to size
- 20131229_080715.jpg (36.33 KiB) Viewed 1295 times
And the finished product
Rob
Re: repairing a broken shaft
Posted: Wed Jan 08, 2014 2:30 am
by TamJeff
Nicely done.
Re: repairing a broken shaft
Posted: Wed Jan 08, 2014 7:40 pm
by Otto Nobedder
Agreed.
Precision work like that is always challenging... Puts your brain to work, as much as your hands.
Steve