Page 1 of 1
Drill press table
Posted: Sun Mar 23, 2014 9:36 pm
by gundog
Looking for some cool ideas for a drill press table for a table mount drill press. I was thinking 29" high so the drill would be at a good height for working. Any hints or ideas would be great.
Re: Drill press table
Posted: Wed Mar 26, 2014 4:20 am
by TamJeff
I would be tempted to make it a tapered three legged, so it would be steady on uneven floors.
My cheap bandsaw at work has a 4 legged stand that is bolted together. I don't have the bolts super tight on the legs, so that I can kick them out until the saw sits right when I have to move it about.
Re: Drill press table
Posted: Thu Mar 27, 2014 10:36 pm
by gundog
At work we use a nut adjustment on one leg. You can always adjust it with one leg moveable.