3 point tractor hitch
Posted: Wed May 14, 2014 4:27 pm
- IMGP2239.JPG (111 KiB) Viewed 1253 times
Page 1 of 1
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 4:36 pm
Very nice!!
Did you build it from scratch?
Did you build it from scratch?
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 4:38 pm
yes - 5x5 angle, draw bar, 6" hitch tube.....
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 4:40 pm
Very nice craftsmanship! I built one similar for a friends Kubota a few weeks ago. Should have taken pictures of it.
-Jonathan
-Jonathan
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 4:42 pm
I bought one a week ago. 
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 4:43 pm
Thanx neighbor-Wooster about an hour north of me
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 4:46 pm
Why don't you take pics of everything you work on??Superiorwelding wrote:Very nice craftsmanship! I built one similar for a friends Kubota a few weeks ago. Should have taken pictures of it.
-Jonathan
I try and document most of the work I do.
Gives assurance to new customers.
Wish I'd of started yrs ago.
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 4:54 pm
Ah -yes- looks good - but what was it welded with ? ( !! ) - careful - AK's reading this ! if 6013 even got near it while you were welding the entire thing may just fly apart killing dozens ! - lucky it only looks like a Cat 1 - if it was bigger that may have been hundreds !
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 5:01 pm
Ha Ha Ha 6010 covered with 7018......
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 5:05 pm
Phew - that's a relief ! your golden then ! - only a thought - but capping the vertical box would keep it from filling up with water / mud & add a little strength.
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 5:10 pm
Good suggestion - thank you...
Re: 3 point tractor hitch
Posted: Wed May 14, 2014 5:17 pm
You da man!!robson1015 wrote:Ha Ha Ha 6010 covered with 7018......
Good choice!!
Re: 3 point tractor hitch
Posted: Thu May 15, 2014 3:17 am
I'd better grind the factory mig welds out, and weld it with 6013.
Got some great 6013 here.
Got some great 6013 here.
- IMG_2203.JPG (102.8 KiB) Viewed 646 times
- IMG_1484.JPG (136.68 KiB) Viewed 646 times