Welding table overhaul
Posted: Sun Dec 28, 2014 6:31 pm
I decided to to a over haul on my welding table, right now it is 3'x6' and I'm gonna make it 3'x4' to gain some space back in the garage one section is 3/8" oiled and pickled plate the other part is a t-slot table from a big knee mill, I am going to incorporate the receiver style accessory ports and possibly cut slots in the plate like the jmr table. All I have done at this point is rough out the legs
To make the legs I cut apart a 4x4 left over from a project
Sent from my iPhone using Tapatalk
- ImageUploadedByTapatalk1419805886.189524.jpg (45.87 KiB) Viewed 932 times
- ImageUploadedByTapatalk1419805873.752146.jpg (52.18 KiB) Viewed 932 times
- ImageUploadedByTapatalk1419805860.322555.jpg (48.63 KiB) Viewed 932 times
- ImageUploadedByTapatalk1419805843.825252.jpg (61.99 KiB) Viewed 932 times
To make the legs I cut apart a 4x4 left over from a project
Sent from my iPhone using Tapatalk