Page 1 of 1
Another project Finished
Posted: Thu May 26, 2016 12:43 am
by YukWelder
Made a cart that will hold mig, tig, and plasma on four wheels.
Re: Another project Finished
Posted: Thu May 26, 2016 7:59 am
by DLewis0289
Nicely capped tubes etc. Damn nice job.
Re: Another project Finished
Posted: Thu May 26, 2016 8:33 am
by YukWelder
The top shelf is angled at 100 degrees for easy reading of front panels. There are no front corner posts for easy access to lower shelves. There are six 1 1/2 x 4 side hooks for leads and electric lines. The filler rod side shelf is 1 1/2 x 10" long. And the tank shelve is large enough to hold 240 bottles. This unit fits through a 32 " door.
Got lucky on the diamond plate, in salvage pile was a full sheet of 14 gauge 4 x 10 with one end ran over by a fork lift. $50...Score!