I'm new so I'm posting an introduction.
I have been welding since 2007, but I do very little of it, so I classified myself as a beginner. My only welding equipment is a Lincoln 180C. I also have a nice plasma cutter, because, well, sawing is for the little people.
Hope I can make a positive contribution to the forum.
- Chips O'Toole
-
Heavy Hitter
-
Posts:
-
Joined:Thu Dec 01, 2016 12:30 pm
-
Location:FL
I was socially distant when social distancing wasn't cool.
- MosquitoMoto
-
Weldmonger
-
Posts:
-
Joined:Sat Aug 01, 2015 8:38 am
-
Location:The Land Down Under
Chips O'Toole wrote:I'm new so I'm posting an introduction.
I have been welding since 2007, but I do very little of it, so I classified myself as a beginner. My only welding equipment is a Lincoln 180C. I also have a nice plasma cutter, because, well, sawing is for the little people.
Hope I can make a positive contribution to the forum.
Chips, between your username and 'sawing is for the little people' I am liking you already.
Welcome.
Kym
- Chips O'Toole
-
Heavy Hitter
-
Posts:
-
Joined:Thu Dec 01, 2016 12:30 pm
-
Location:FL
Thanks.Chips, between your username and 'sawing is for the little people' I am liking you already.
Welcome.
Kym
I just can't see the logic in taking 3 minutes to cut something with a grinder when I can take 15 minutes to set it up and vaporize it with hot plasma.
I was socially distant when social distancing wasn't cool.
dayum , don't be dissin my circa 1983 17lb Millwalke sawzall.Chips O'Toole wrote:I'm new so I'm posting an introduction.
I have been welding since 2007, but I do very little of it, so I classified myself as a beginner. My only welding equipment is a Lincoln 180C. I also have a nice plasma cutter, because, well, sawing is for the little people.
Hope I can make a positive contribution to the forum.
