derailment
- derailment
-
New Member
-
Posts:
-
Joined:Thu Dec 08, 2011 12:46 am
I have a project where I need to join steel and copper sheet with a lap weld. Advice so far is to use silicon bronze rod and only heat to fill the gap with rod. Any advice or recommendations?
Greg From K/W
- Greg From K/W
-
Ace
-
Posts:
-
Joined:Sun Nov 27, 2011 8:55 pm
I would do it that way. Sheet steel used to be only joined with brazing rod in body work why not to brass or copper? Now it is done with a mig welder.
nova_70_383
- nova_70_383
-
Guide
-
Posts:
-
Joined:Fri Nov 06, 2009 5:51 pm
alumibronze rod will work too. some places call it A2 or A10