Tig welding tips, questions, equipment, applications, instructions, techniques, tig welding machines, troubleshooting tig welding process
Nervous
Post Reply
nelson
  • Posts:
  • Joined:
    Sun Jul 17, 2016 1:21 pm
  • Location:
    near philly

Hi, I have this mold to repair. This is one of 2 slides. The apex left of center has to be built up. There are 4 total areas to fix.
I have a PUK 3 micro but it needs work so I can't use that. Are there videos addressing something like this?
Any thoughts on it, weld away from it to start then build it up?

Respect to those who gave it all.

Thanks!
1685291481605-1252292240.jpg
1685291481605-1252292240.jpg (1.87 MiB) Viewed 3455 times
Stone knives and bearskins.....and a NEW EVERLAST 164SI !!!
That's my newly shared work welder.
At home I got a Power Tig 185 DV. Nice, but no plasma cutting... Nice tight arc after a second.
Top
nelson
  • Posts:
  • Joined:
    Sun Jul 17, 2016 1:21 pm
  • Location:
    near philly

It's H13 pulled back to about 45RC. I have 1/16" P20 rod. I have to schlock this back into production until the new 2 cavity mold is done. Backorders !!!
Stone knives and bearskins.....and a NEW EVERLAST 164SI !!!
That's my newly shared work welder.
At home I got a Power Tig 185 DV. Nice, but no plasma cutting... Nice tight arc after a second.
Top
nelson
  • Posts:
  • Joined:
    Sun Jul 17, 2016 1:21 pm
  • Location:
    near philly

Well it worked.
Anyone know of a repair shop for my PUK3 micro TIG? I don't think it's putting out full power. .020" tungsten. I'm near Philly.
Stone knives and bearskins.....and a NEW EVERLAST 164SI !!!
That's my newly shared work welder.
At home I got a Power Tig 185 DV. Nice, but no plasma cutting... Nice tight arc after a second.
Top
Post Reply

Return to “Tig Welding - Tig Welding Aluminum - Tig Welding Techniques - Aluminum Tig Welding”