I cant seem to find one..the nozzle, on the mig, is held in place by a "C" type spring clip in the nozzle 
any idea where I can buy one 
- weldin mike 27
-
Weldmonger
-
Posts:
-
Joined:Fri Apr 01, 2011 10:59 pm
-
Location:Australia; Victoria
Hi there,
We made our own. A sleave of copper silver soldered onto the outside of a normal shroud/ nozzle. The end of the shroud sits square on the job, this sets the height and holds the gun square. With a little notch on each side to let the smoke and stuff escape. May need to do a couple of tests to get the height right. Remove the chrome plating (if any) on the nozzle. Not sure if it will solder well.
Mick
We made our own. A sleave of copper silver soldered onto the outside of a normal shroud/ nozzle. The end of the shroud sits square on the job, this sets the height and holds the gun square. With a little notch on each side to let the smoke and stuff escape. May need to do a couple of tests to get the height right. Remove the chrome plating (if any) on the nozzle. Not sure if it will solder well.
Mick
donaldsanchez
- donaldsanchez
-
New Member
-
Posts:
-
Joined:Fri Nov 23, 2012 4:15 am
If you want to buy a good quality welding nozzle then can buy it with the help of our company which is one of the best in making welding equipment. Te quality of our products re very good and can easily afforded from anywhere.
_____________________
Spot welding tips
_____________________
Spot welding tips