[PaterNovem]

So, got a welder as I've always wanted to learn. Been around it for years at work and family. I get set up and build a decent size table. Nothing fancy here, nothing like some of the ones seen in the forums. I still need to put a shelf in the bottom. And the wheels while rated for quite a bit will have to see how they hold up. May replace with leveling wheels at some point. The top is 1/2 inch steel that I had water jetted. I did add the hangers for clamps on the sides; saw that here and it's a great idea.

[weldin mike 27]

Hey,

That looks very cool. Great job for a first project.

PS: I like your msg in your footer. My kids watch waaaaaaayy too much tv.

Mick

[nathan]

I've always wondered what those slots are for. My table at work is a whole single 48X120 sheet of 1" hot roll, so it doesn't have the fancy stuff like that.

[Oddjob83]

with those keyed slots what kind of clap system uses those? it looks like those Miller ArcStations
http://www.millerwelds.com/products/wor ... rcstation/

[jwmacawful]

i like the cutouts on the top. nice looking job.

[TamJeff]

That would be perfect for most that I do. Nice job on that.