Welcome to the community! Tell us about yourself, your welding interests, skills, specialties, equipment, etc.
Old but, new
Post Reply
shoebox1956
  • Posts:
  • Joined:
    Sat Feb 22, 2014 6:23 am
  • Location:
    New Freedom, PA

Hello,
Just registered. I have been receiving Jody's videos for over 3 years or longer. Very informative. I have an old P&H heliarc welder that is now hooked up with an air cooled WP17 torch and I also have a MIG welder from Eastwood and it came with the spoolgun. I grew up with oxy/acetylene and my garage is now about set up to do some work. I have a '56 Chevy that I am going to do a frame off restoration. Lots of sheet metal to replace/repair. Now I have to start practicing. So, Hello everyone.
Paul
Top
User avatar
  • Posts:
  • Joined:
    Thu Jan 24, 2013 10:13 pm
  • Location:
    Eddy, TX

Paul,
Welcome to the forum! I would like to see a pic of your P&H, I love looking at the old welders. Keep us up to date with your progress on the 56.
-Jonathan
Top
Mike
  • Posts:
  • Joined:
    Mon Dec 06, 2010 1:09 pm
  • Location:
    Andover, Ohio

Welcome to the forum Paul.
M J Mauer Andover, Ohio

Linoln A/C 225
Everlast PA 200
Top
User avatar
  • Posts:
  • Joined:
    Wed Oct 23, 2013 3:30 pm
  • Location:
    Palmer AK

Welcome to the forum.

~John
Just a couple welders and a couple of big hammers and torches.

Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Top
paul_s
  • Posts:
  • Joined:
    Thu Feb 06, 2014 10:04 pm
  • Location:
    SW Florida

Welcome to the forum from another Paul.
Top
Post Reply

Return to “Member Introductions”