Custom barrel stand.

AKweldshop · Wed Feb 11, 2015 4:21 pm

1 1/2" angle iron. 1/8" thick.
Angles cut on the corners.
Fitting up into a square frame.

: IMG_1771.JPG (101.99 KiB) Viewed 1496 times

: IMG_1774.JPG (47.57 KiB) Viewed 1496 times

: IMG_1777.JPG (93.24 KiB) Viewed 1496 times

AKweldshop · Wed Feb 11, 2015 4:24 pm

: IMG_1778.JPG (54.04 KiB) Viewed 1495 times

: IMG_1784.JPG (85.47 KiB) Viewed 1495 times

: IMG_1785.JPG (43.59 KiB) Viewed 1495 times

AKweldshop · Wed Feb 11, 2015 4:27 pm

: IMG_1786.JPG (106.66 KiB) Viewed 1495 times

: IMG_1788.JPG (57.3 KiB) Viewed 1495 times

: IMG_1793.JPG (81.98 KiB) Viewed 1495 times

AKweldshop · Wed Feb 11, 2015 4:30 pm

: IMG_1798.JPG (79.46 KiB) Viewed 1495 times

: IMG_1797.JPG (81.35 KiB) Viewed 1495 times

: IMG_1799.JPG (81.51 KiB) Viewed 1495 times

RookieWelder · Thu Feb 12, 2015 6:28 pm

Nicely done! Nothing wrong with that project that I can see.

Dwight

Bill Beauregard · Thu Feb 12, 2015 8:06 pm

Have you considered adding four more pieces of angle to make it an octagon it sits on instead of a square, It would add strength.

AKweldshop · Mon Feb 16, 2015 4:21 pm

Bill Beauregard wrote:Have you considered adding four more pieces of angle to make it an octagon it sits on instead of a square, It would add strength.

That takes ability, out of my skill level....

RookieWelder wrote:Nicely done! Nothing wrong with that project that I can see.

Dwight

I sure hope not.

Braehill · Mon Feb 16, 2015 5:41 pm

John,
Outside of the obvious, what is the barrel stand's purpose? We can see it's to hold a barrel up, but why does it need to be raised? Is it a burn barrel and needs air to pass under, or for collecting rain water, or some other reason? Just curious.

Nice job by the way.

Len

AKweldshop · Mon Feb 16, 2015 6:02 pm

Braehill wrote:John,
Outside of the obvious, what is the barrel stand's purpose? We can see it's to hold a barrel up, but why does it need to be raised? Is it a burn barrel and needs air to pass under, or for collecting rain water, or some other reason? Just curious.

Nice job by the way.

Len

I think the guy will cut slots in the bottom for vents.

I'm not really sure.

It was just a quick fab job for a friend.

Braehill · Mon Feb 16, 2015 6:06 pm

I usually just cut holes in the bottom with an O/A torch and set a burn barrel up on a couple bricks, but the stand would work too.

Len

AKweldshop · Mon Feb 16, 2015 7:07 pm

Braehill wrote:I usually just cut holes in the bottom with an O/A torch and set a burn barrel up on a couple bricks, but the stand would work too.

Len

You can't weld bricks.....