Metal cutting - oxyfuel cutting, plasma cutting, machining, grinding, and other preparatory work.
jack_of_all
  • Posts:
  • Joined:
    Mon Sep 07, 2015 5:32 pm

I find that I don't fire up the Oxy-Acetylene rig very often now that I have Plasma and TIG. I only use it for cutting thick metals and welding thin metals that will need a lot of forming.

Other than the normal safety start-up and storage procedures, are there things to consider when an Oxy-fuel rig sits idle for months at a time between use? I'm sure hoses need to be inspected. How about the tank, gas, regulator, torch......? The gases can't 'go bad' can they?
Artie F. Emm
  • Posts:
  • Joined:
    Thu Jul 24, 2014 7:53 am

I worked at a LWS for a few years, and never heard of gas going bad or stale. Over a long period of time hoses can dry rot; diaphragms in regulators and o-rings in torch valves can dry out and leak. But that's a long time out. Seems like you"re more likely to find you have a slow leak in a cylinder valve, when you go to turn on the gas and there's no pressure in the cylinder.
Dave
aka "RTFM"
User avatar
  • Posts:
  • Joined:
    Fri Nov 20, 2015 12:27 am
  • Location:
    Sydney, Australia

Thanks Artie for sharing a response from a professional perspective having worked at LWS for a few years. I also think that with the correct storage procedures, you should not face much problems as gas does not “go bad” to my knowledge. Nevertheless, I do think that eventually if left abandoned it will escape and be empty.
Post Reply