[BooRadley]

I will be welding (MIG) up some 1/8" mild steel soon for a test. 2f and 3f positions. It's been a little while since I MIG welded, and I don't have access to a MIG welder at this time. Please tell me, what voltage setting and wire speed setting do you recommend starting at? (I know to experiment a bit to see what works best, I just need a very good starting point).

Thanks.

[Sarge]

Assuming solid wire and gas... .035? If so, I like to go a little slower on a test and would likely start at 19 and 195 wire speed. All depends on your welding style.

[BooRadley]

Thanks, Sarge. That is very helpful information. Yes, it will likely be 035. Also solid wire and gas. CO2, I think? Been awhile.


Steph

[bearston]

I'm sure your job is done by now, but for the future, I think that this welding calculator link might be very helpful for you.